When we talk about stainless steel rolls, the common problem is what to do if they are deformed during the welding process. Because welding deformation is inevitable in stainless steel welding. Generally speaking, if it is a stainless steel shot, then the weld size and number of welds will be reduced as much as possible. If the stainless steel rollers are deformed during the welding process, in order to ensure the symmetry between the welds and the stainless steel welded parts, their positions should also be as close to the central axis of the components as possible. This is done to avoid over-concentration of the weld. In order to prevent deformation, it is necessary to pay a little attention during the operation.
Of course, if the stainless steel roller is deformed during the welding process, in order to prevent it from being too large in the welding seam, the welding sequence should be arranged in a scientific and reasonable manner. If you see that some long components are distorted. You can do this by raising the assembly part of the member so that the steel plate is flat. It is also for better calibration of the gap and bevel angles. It is also to ensure the longitudinal deformation of the web flange inside. And their length and direction are the same when deforming. We should also ensure that the arc is pointing. When both its front and back sides can be welded, a double-sided symmetrical groove can be used at this time; only in this way can the welding area be effectively reduced and the integrity of the weld be ensured.
In short, in order to have a completeness in the stainless steel roll and welding, the above methods of how to prevent it from deforming still need to master the following. Although it is very simple to operate, as long as you do not follow the requirements, there will be deformation.
National sales hotline: 0512-57899387
Mobile number: 13806267510
Email: sales@ytroll.com
Address: No. 1, Zhengyi Mingzhu Road, Bacheng Town,
WeChat scan
Mobile official website
